Wednesday, March 17, 2010

WB-D

WB-8

EMC2 (Polywell Fusion) has updated their site with an image of WB-8 shown above. The Drawing is labeled as "with diagnostics".

And then there is this picture:



Labeled:
WB-D 100MW Polywell Demo Device

Your Contributions Will Help Us Design The WB-D Polywell Device

Send your supporting contributions to:

New Mexico Community Foundation

Contact Energy Matter Conversion Corporation

1202 Parkway Drive Suite A
Santa Fe, NM 87507
Phone: 505-471-2050
Email: Rick at Emc2fusion dot com
There is considerable speculation at Talk Polywell as to what it all means.

And since from time to time there are people reading here who need to be brought up to speed on fusion I'm reposting my usual: You can learn the basics of fusion energy by reading Principles of Fusion Energy: An Introduction to Fusion Energy for Students of Science and Engineering

Polywell is a little more complicated. You can learn more about Polywell and its potential at: Bussard's IEC Fusion Technology (Polywell Fusion) Explained

The American Thinker has a good article up with the basics.

And the best part? We Will Know In Two Years or less.

I'm a big fan of small fusion projects. Especially after hearing what Plasma Physicist and author of Principles of Plasma PhysicsDr. Nicholas Krall said, "We spent $15 billion dollars studying tokamaks and what we learned about them is that they are no damn good." And they seem really hard to build even. And who knows, if the Polywell experiments being done by the US Navy are successful the ITER project may just wind up as a big hole in the ground in France.

Update:

Here is the progress report given so far by EMC2:
EMC2 Fusion Development Corporation has been formed as a charitable research and development organization in frontier energy technologies with emphasis on fusion.

Fusion R&D Phase 1 - Validate and extend WB-6 results with WB-7 Device: 1.5 years / $1.8M, Successfully Completed

Fusion R&D Phase 2 - Design, build and test larger scale WB-8 Polywell Device: 2 years / $7M, In Process

Fusion R&D Phase 3 - Design, build and test full scale 100 MW Fusion System: 4 years / $200M, In Design Phase

Successful Phase 3 marks the end of fossil fuels
Good luck and happy fusing to the EMC2 folks and Rick Nebel who is leading the project.

Cross Posted at Classical Values

4 comments:

Anonymous said...

As Nebel says, looks like she'll run like a top...



...in Solidworks

Anonymous said...

Oh, and please tell your faithful readers how the Polywell FOIA request turned out??

Unknown said...

Good point. Would a refused FOIA-request be seen as support from the Obama-administration?

Btw - I'm half-sure that FOIA-requests only apply for government-funded and governmental organizations. I don't think that has changed for the US yet, has it?

-S

M. Simon said...

simentt,

The FOIA request was turned down. A resubmission may be in the offing.

The reason given for the denial was proprietary information.

I have contacted a Journalist who follows Polywell and has access to EMC2 and there may be something coming out today. If so I will do a post.